Low FPS at Argyle (TVSA)
Posted: Thu Apr 04, 2019 3:09 pm
I purchased your St Vincents scenery a few days ago and immediately ran into an FPS problem.
My System Specs:
X-Plane 11.26 and FSX/Accel | Windows10 64bit
Motherboard: MSI760GM-E51(MS-7596)
CPU: 3.9GHz AMD FX-4300 Quad-Core | RAM: 16GB DDR3 1333
GPU: NVidia GTX 970 (4GB GDDR5)
I loaded into the runway start position (active runway) and initially everything seemed fine until I started to move. I was getting single digit fps and pauses or "lags" that lasted about 6-8 seconds. It was the same all over the Island. I normally have my autogen pretty high so I dropped it to normal but that made little difference. I reduced the water effects to "0" and still the problem remained. I was flying the FSX default Ultralight at the time. I finally gave up and contacted JustFlight. They helped as much as they could with various suggestions but finally advise to contact your support forum.
Having said all this leads me to what I have found . . . .I went back to Argyle and started flying around the Airport itself, nowhere else. Initially I was pausing more than I was flying and stuttering was constant. I flew in that small area for approx. 5 minutes and at the end of that time the fps had climbed back to 30+ and the stutters and pauses were gone. So I headed up and over the hill to check the rest of the Island. . .as soon as I left the airport the stuttering and pauses and low fps returned. I performed the same routine I had just used at the airport and after a sufficient time of flying around the Island the fps had again risen to normal levels.
After not flying there for several days I tried again and the airport area seems to show some stuttering but that disappears after a few minutes. The rest of the Island seems to be a different story as it takes some time before the fps comes back up to the same level as the airport.
Is this something you're aware of or is it something new?
My System Specs:
X-Plane 11.26 and FSX/Accel | Windows10 64bit
Motherboard: MSI760GM-E51(MS-7596)
CPU: 3.9GHz AMD FX-4300 Quad-Core | RAM: 16GB DDR3 1333
GPU: NVidia GTX 970 (4GB GDDR5)
I loaded into the runway start position (active runway) and initially everything seemed fine until I started to move. I was getting single digit fps and pauses or "lags" that lasted about 6-8 seconds. It was the same all over the Island. I normally have my autogen pretty high so I dropped it to normal but that made little difference. I reduced the water effects to "0" and still the problem remained. I was flying the FSX default Ultralight at the time. I finally gave up and contacted JustFlight. They helped as much as they could with various suggestions but finally advise to contact your support forum.
Having said all this leads me to what I have found . . . .I went back to Argyle and started flying around the Airport itself, nowhere else. Initially I was pausing more than I was flying and stuttering was constant. I flew in that small area for approx. 5 minutes and at the end of that time the fps had climbed back to 30+ and the stutters and pauses were gone. So I headed up and over the hill to check the rest of the Island. . .as soon as I left the airport the stuttering and pauses and low fps returned. I performed the same routine I had just used at the airport and after a sufficient time of flying around the Island the fps had again risen to normal levels.
After not flying there for several days I tried again and the airport area seems to show some stuttering but that disappears after a few minutes. The rest of the Island seems to be a different story as it takes some time before the fps comes back up to the same level as the airport.
Is this something you're aware of or is it something new?