Graz: Square of Autogen missing in front of RWY17C
Posted: Sat Dec 10, 2016 7:49 pm
Dear FSDG,
I've just bought your Graz scenery and noticed an anomaly after installation:
Right after the airport boundary on short final for RWY17C I see a big chunk of autogen missing, see attached picture. I'm using P3D V3.4 together with ORBX FTX Global, OpenLC EU and Vector (with only major roads and highways enabled).
The rest of the airport surroundings is completely fine with no gaps in autogen. The short final on the opposite runway looks just fine as well.
Have you seen this problem before? Is there anything I can do about this? It is a bit of an immersion killer, as this flat area is right on short final and is overflown at very low altitude, thus extremely well visible. If this were anywhere else but on the runway axis, I wouldn't even report it. But this is right on short final where your eyes can't miss it, so I'd be really happy if this could be resolved somehow!
Your help is greatly appreciated.
Thanks,
Markus
I've just bought your Graz scenery and noticed an anomaly after installation:
Right after the airport boundary on short final for RWY17C I see a big chunk of autogen missing, see attached picture. I'm using P3D V3.4 together with ORBX FTX Global, OpenLC EU and Vector (with only major roads and highways enabled).
The rest of the airport surroundings is completely fine with no gaps in autogen. The short final on the opposite runway looks just fine as well.
Have you seen this problem before? Is there anything I can do about this? It is a bit of an immersion killer, as this flat area is right on short final and is overflown at very low altitude, thus extremely well visible. If this were anywhere else but on the runway axis, I wouldn't even report it. But this is right on short final where your eyes can't miss it, so I'd be really happy if this could be resolved somehow!
Your help is greatly appreciated.
Thanks,
Markus
